Waterproof and moisture-proof is the key to bathro

2022-07-22
  • Detail

Precautions for bathroom decoration waterproof and moisture-proof is the key. I. the threshold is a barrier to prevent water from overflowing from the bathroom. Its design and construction points are as follows: 1) the upper plane of the threshold should be inclined to the inside of the bathroom, so that water droplets can slide smoothly to the inside of the bathroom; 2) the threshold should be the same width as the door frame, and the door frame should be the same thickness as the wall, so that there will be no big difference when laying floor tiles, and the chance of creating a breach will be relatively reduced. II. Ground waterproof

precautions for bathroom decoration waterproof and moisture-proof is the key

I. threshold

threshold is a barrier to prevent water from overflowing from the bathroom. Its design and construction points include:

1) the upper plane of the threshold should be inclined to the inside of the bathroom, so that water droplets can slide smoothly to the inside of the bathroom

2) the threshold should be the same width as the door frame, and the door frame should be the same thickness as the wall, so that there will be no big difference when laying floor tiles, and the chance of creating a breach will be relatively reduced

II. Ground waterproof

there are many kinds of waterproof materials. At present, waterproof agents are widely used. When laying the waterproof layer, it should be paved to about 20 cm above the foot of the wall, and at least not lower than the height of the threshold. When there is a reserved pipe on the floor, the waterproof layer also needs to cover the reserved pipe. After the floor is waterproof and dry, cement mortar must be used for priming or protective measures must be taken immediately to prevent the waterproof layer from being damaged

III. floor tile laying

there are three main points for floor tile laying:

1) there should be a drainage slope of about 1%, and the slope faces the water inlet under the floor

2) the floor tile joint should be the same thickness and aligned with the wall tile joint

3) when the front wall of the bathtub is paved with bricks, it is best to stick the floor tiles below the wall first, and then stick the wall tiles to avoid cracks

IV. the washing table top

the washing table top should be "all-round" (that is, the surface material of the table top is consistent with the composition and color of the internal material), and the table top with only one layer of surface glue shell cannot be selected, because the table top with only surface glue shell cannot be repaired once it is damaged. (to check whether the table top is "all-in-one", the light can be used to irradiate from the back at a close distance, and the table top that can transmit light is "all-in-one"). In addition, caulking agent must be applied at the joints between the table top and the washbasin to prevent water from seeping out from the joints

v. toilet

generally, when installing the toilet, it is used to fix the toilet with cement mortar. In fact, this method is wrong. After fixing the toilet with this method, the toilet cannot be disassembled again. If the pipeline is seriously blocked, there is only one way to knock off the toilet

济南男科医院

咸阳肿瘤医院

成都耳鼻喉医院

Copyright © 2011 JIN SHI